Practice 350-601 Questions With Certification guide Q&A from Training Expert ValidBraindumps
Free Cisco 350-601 Test Practice Test Questions Exam Dumps
NEW QUESTION # 158
Drag and drop the NAS features from the left onto the NAS descriptions on the right. Not all features are used
Answer:
Explanation:
NEW QUESTION # 159 
Refer to the exhibit. The Cisco Nexus Series Switches SW1, SW2, and SW3 are connected via Layer 2 copper interfaces. An engineer implements loop prevention standard IEEE 802.1w on each VLAN lo provide lasier recovery from network changes or failures. The Implementation has these requirements
* Interfaces that are connected to Layer 2 hosts must not receive STP BPDUs.
* The implementation must detect unidirectional links due to one-way traffic twisted-pair links
* Bridge assurance must be enabled between SW2 and SW3
* The Layer 2 domain must be protected from superior BPDUs that arrive from external switches.
Drag and drop the code snippets from the right onto the blanks in the code on the left to complete the configuration for SW3. Not all code snippets are used.
Answer:
Explanation:
Explanation
Network
Aggressive
Bpdu
edge
NEW QUESTION # 160
Refer to the exhibit.
Which command is run from the Guest Shell to set the description on the first five interfaces of the Cisco Nexus switch?
- A. Option C
- B. Option D
- C. Option A
- D. Option B
Answer: B
NEW QUESTION # 161
Which service profile is affected if the default host firmware policy in Cisco UCS Manager is changed?
- A. any service profile that uses a user-created host firmware policy
- B. any service profile that has no host firmware policy defined
- C. any service profile that is not in the root sub-org
- D. any service profile that uses the global-default host firmware policy
Answer: D
Explanation:
Section: Compute
NEW QUESTION # 162
Refer to the exhibit.
Refer to the exhibit. Which feature must be used to configure on switch 2 to establish a VSAN trunk between switch 1 and switch 2?
- A. N Port
Trunk Mode Active - B. E Port
Trunk Mode On - C. F port
Trunk Mode Passive - D. NP Port
Trunk Mode Auto
Answer: B
NEW QUESTION # 163
An engineer needs to implement a solution that will provide telemetry of MDS 9000 switches in a SAN fabric.
The solution should use Cisco Data Center Network Manager (DCNIM) with SAN insights feature. Which three steps are required to deploy the solution? (Choose Three.)
- A. Activate SAN_ANALYTICS_PKG license on target switches
- B. Configure name resolution between the devices
- C. Select a target VSAN to be monitored
- D. Select a target Fabric to be monitored.
- E. Select the target ports to be monitored for telemetry data
- F. Activate ENTERPRISE_PKG license on target switches
Answer: A,D,E
NEW QUESTION # 164
What is a benefit of Cisco HyperFlex All-Flash Stretched cluster deployment as compared to All-HDD Stretched cluster deployment?
- A. higher number of IOPS
- B. lower number of IOPS
- C. lower cost
- D. higher cost
Answer: A
NEW QUESTION # 165
A host in EPG Client wants to talk to a webserver in EPG Web. A contract with default settings is defined between EPG Client and EPG Web, which allows TCP communication initiated by the client toward the webserver with TCP destination port 80.
Which statement describes this scenario?
- A. If EPG Web is made a preferred group member, a contract between EPG Client and EPG Web is no longer required for the host in EPG Client to reach the webserver in EPG Web.
- B. The host in EPG Client is allowed to connect to TCP destination port 80 on the webserver in EPG Web.
The webserver is allowed to initiate a separate TCP connection to a host port with TCP source port 80. - C. If vzAny is configured to consume and provide a "deny all" contract, traffic between EPG Client and EPG Web is no longer allowed.
- D. The host in EPG Client is allowed to connect to TCP destination port 80 on the webserver in EPG Web.
The webserver will not be allowed to initiate a separate TCP connection to a host port with TCP source port
80.
Answer: B
Explanation:
Section: Security
NEW QUESTION # 166
Refer to the exhibit.
An engineer needs to implement a monitoring session that should meet the following requirements:
* Monitor traffic from leaf to leaf switches on a Cisco ACI network
* Support filtering traffic from Bridge Domain or VRF
Which configuration must be added to meet these requirements?
- A. interface eth 1/2 leaf 101
- B. filter tenant t1 application app1 epg epg1
- C. application epg epg1 app1
- D. interface eth 1/2 switch 101
Answer: B
NEW QUESTION # 167
A storage engineer must configure zoning on a Cisco MDS 9000 Series switch. Drag and drop actions from the left into the order on right
Answer:
Explanation:
Explanation
A, B, F, D, C, E
NEW QUESTION # 168
Due to new regulatory requirements from a third party, organization ABC must enable two-factor authentication for the Cisco UCS environment. The requirement is also to provide redundancy if the authentication server goes offline. Which three authentication components must be enabled to meet this requirement? (Choose three.)
- A. local
- B. provider group
- C. authentication domain
- D. TACACS+
- E. LDAP
Answer: B,C,D
Explanation:
Explanation
https://www.cisco.com/c/en/us/td/docs/unified_computing/ucs/ucs-manager/GUI-User-Guides/Admin-Managem
NEW QUESTION # 169
Drag and drop the firmware packages from the left onto the software bundles they belong to on the right.
Answer:
Explanation:
Explanation
Diagram Description automatically generated
NEW QUESTION # 170
Which statement about monitoring Fibre Channel traffic on a Cisco UCS 6332 Fabric Interconnect is true?
- A. Fibre Channel traffic can be monitored as it is encapsulated as FCoE.
- B. The destination port for monitoring must be an unassigned Fibre Channel port.
- C. The monitoring of Fibre Channel traffic is limited to the default VSAN.
- D. Fibre Channel traffic can be monitored only on one vHBA per server.
Answer: D
NEW QUESTION # 171
A customer has a requirement for an automation solution that supports periodically acquiring configuration from a centralized server and aligning UCS servers to their desired state. Which open-source tool meets these requirements?
- A. Kubemetes
- B. Puppet
- C. Terraform
- D. SaltStack
Answer: B
Explanation:
"Overview of Puppet architecture: [...] After it receives a catalog, the Puppet agent applies the catalog by checking each resource that the catalog describes. If it finds any resources that are not in their desired state, it makes any changes necessary to correct them."
https://www.cisco.com/c/dam/en/us/products/collateral/servers-unified-computing/ucs-c-series-rackservers/ whitepaper_c11-740103.pdf
https://www.cisco.com/c/dam/en/us/products/collateral/servers-unified-computing/ucs-devops-integration-sol-brief.pdf from DCCOR book under Puppet section The operation of the Puppet agent involves periodically connecting to the Puppet master, which in turn compiles and sends a configuration manifest to the agent. The agent reconciles this manifest with the current state of the node and updates state that is based on differences.
NEW QUESTION # 172
A network engineer configures a converged network adapter (CNA) and must associate a virtual fiber Channel 7 interface to VSAN 7. The CAN connected to the interface Eth1/7, and VLAN 700 is mapped to the VSNA.
Which configuration must be applied to create the virtual Fiber Channel interface and associate it with the Ethernet physical interface?
A)
B)
C)
- A. Option C
- B. Option D
- C. Option A
- D. Option B
Answer: B
NEW QUESTION # 173 
Refer to the exhibit During a vPC peer switch reload, there is packet loss between the server and the router Which action must be taken to prevent this behavior during future reloads?
- A. Decrease the OSPF hello and dead interval timers.
- B. Set the routed uplink ports of the Cisco Nexus peers as orphans.
- C. Increase the vPC delay restore timer.
- D. Disable vPC ARP synchronize on the vPC peers.
Answer: C
NEW QUESTION # 174
Which statement about the MAC address that the FCoE Initialization Protocol chooses for use by an E-Node in an FCoE implementation is true?
- A. The FCoE Initialization Protocol uses the burned-in MAC address of the converged network adapter for all FCoE operations.
- B. FCoE does not use a MAC address. The FCoE Initialization Protocol is used to acquire a Fibre Channel ID, and the address is used for all FCoE communications in the same way as Fibre Channel Protocol.
- C. The FCoE Initialization Protocol uses 01.00.0C as the first 24 bits of the MAC address and appends a 24-bit Fibre Channel ID to derive a full 48-bit FCoE MAC address.
- D. The FCoE Initialization protocol uses a 24-bit FC-MAP and concatenates a 24-bit Fibre Channel ID to create a fibric-provided MAC address.
Answer: D
Explanation:
https://www.cisco.com/c/en/us/td/docs/solutions/Enterprise/Data_Center/UF_FCoE_final.html#wp1154912
NEW QUESTION # 175
Refer to the exhibit.
Which setting must be configured to prevent reuse of passwords?
- A. Change Count
- B. History Count
- C. No Change Interval
- D. Change Interval
Answer: B
Explanation:
https://www.cisco.com/c/en/us/td/docs/unified_computing/ucs/ucs-manager/GUI-User-Guides/Admin- Management/3-1/b_Cisco_UCS_Admin_Mgmt_Guide_3_1/ b_Cisco_UCS_Admin_Mgmt_Guide_3_1_chapter_011.html
NEW QUESTION # 176
An engineer mus! configure HSRP protocol on two Cisco Nexus 9000 Series Switches running a virtual port channel. In addition, the HSRP implementation must meet these requirements:
It must allow more than 500 groups.
switch 1 must act as the primary switch.
Both switches must use a user-defined hardware address.
Drag and drop the commands from the right to complete a configuration of the HSRP on the left. The commands are used more than once. Not all commands are used.
Answer:
Explanation:
NEW QUESTION # 177
An engineer changed a configuration and must perform a rollback.
Which statement applies to a Cisco Nexus 5600 Series Switch?
- A. A system checkpoint is generated automatically when the running configuration is saved to NVRAM.
- B. Errors are skipped when an atomic rollback type is triggered.
- C. The configuration rollback functionality is disabled when FCoE is enabled.
- D. A user who is assigned to the network-operator user role is allowed to perform a rollback.
Answer: C
Explanation:
Section: Compute
NEW QUESTION # 178
A company is running a pair of cisco Nexus 7706 series switches as part of a data center segment. All network engineers have restricted read-Write access to the core switches. A network engineer must a new FCoE VLAN to allow traffic from services toward FCoE storage. Which set of actions must be taken to meet these requirements?
- A. 1. Assign the network-admin role to a user.
2. Commit the role to the switch to the active user database - B. 1. Modify a network-operator role and add the required privileges.
2. Assign a VDC-operator role to a user. - C. 1. Add the required privilege to the VDC-admin role.
2. Commit the changes to the active user database. - D. 1. Create a user defined role and add the required privileges.
2. Assign a role to a user.
Answer: C
NEW QUESTION # 179
An engineer is implementing traffic monitoring for a server vNIC that is configured with fabric failover enabled. The requirement is for the traffic to be sent to an analyzer, even during a failure of one of the fabric interconnects. The analyzer is connected to unconfigured Ethernet ports on both fabric interconnects. Which configuration accomplishes this task?
- A. Create two traffic monitoring session with different names, one per fabric Connect the analyzer connected to FI-BI the destination for both monitoring sessions.
- B. Option C
- C. Option D
- D. Option A
- E. Option B
- F. Connect an analyser on each FI as the destination for the monitoring session local to the FI.
- G. Create two traffic monitoring sessions with the same name, one per fabric Connect the analyze connected to FI-A as the destination for both monitoring sessions
- H. Create two traffic monitoring session with different names, one per fabric.
Answer: A
NEW QUESTION # 180
......
Cisco 350-601 certification exam is an essential requirement for professionals looking to advance their careers in the data center industry. Implementing Cisco Data Center Core Technologies (350-601 DCCOR) certification demonstrates the candidate's skills and knowledge in implementing and managing complex data center solutions, making them highly valuable to organizations. Implementing Cisco Data Center Core Technologies (350-601 DCCOR) certification is recognized globally and is highly valued by employers, making it an excellent investment for professionals looking to grow their data center careers.
Cisco 350-601 certification exam is an important credential for individuals who want to demonstrate their expertise in implementing data center technologies. Implementing Cisco Data Center Core Technologies (350-601 DCCOR) certification is recognized by industry experts and can help professionals advance their careers in the field of data center technology. By passing 350-601 exam, candidates can demonstrate their ability to design, implement, and manage complex data center infrastructure solutions.
Prepare Top Cisco 350-601 Exam Audio Study Guide Practice Questions Edition: https://examsboost.validbraindumps.com/350-601-exam-prep.html